Re-pinning a pinball connector (.100″ Bally/Stern MPU connectors)

In the process of working on a 70s-era, early solid-state pinball machine from Stern (MPU-100 series), I had a need to rebuild one of the connectors, so I thought I might make a video. In this case I’m re-building the smaller .100″ connector. At some point in the future I’d prefer to make a better video of this process on a bench, but unfortunately, most of the time when you’re working on these connectors, you’re huddled over the machine messing with the wiring harness.

Be Sociable, Share!

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.