Fabricating a new lane guide for a Flash Gordon, reinforcing with metal and touch-up painting and protecting

In this installment, I’m working on a Flash Gordon pinball machine. There’s a common plastic part that breaks that is very difficult or expensive to replace. I go over how to replace this part by fabricating your own plastic lane guide using common parts from local hardware stores.

In Part 2, I take things a step further by adding a metal reinforcement plate to keep the guide from breaking in the future, and I show off some amazing playfield paint touch up work and use lacquer to seal the touch-ups:

Be Sociable, Share!

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.