Fixing a dead dot matrix display board

The other day the DMD just went “poof” on one of my machines.  After doing a little research, and checking connections and things, I realized the DMD board died.  In this installment, I walk through the process of rebuilding the power supply-portion of a Bally/Williams WPC DMD board.  In part 1 I describe what I’m doing and introduce you to the tools I’m using.

 

Next up, let’s talk about using a meter to check circuit board traces as we go along..

Desoldering and replacing components.

Now the moment of truth!  One thing I want to add is pay very close attention to each item you are replacing on these boards.  Two diodes, capacitors or transistors may look alike, but have slightly different values or part #s.  The three power transistors and the diodes are not all the same.  You may have to bust out a magnifying glass to note the different in the markings on each part.  This should also be cross-referenced with the schematics and/or parts list from the game manual.

9 thoughts on “Fixing a dead dot matrix display board

  1. I’m having exactly the same problem with my RS. Did you find out what fried the HV section? Has your STTNG been working or was some other issues with display or power supply?

    • My STTNG is working fine. The heat and stress on the high voltage part of the video board causes components to fail. Replacing certain parts made it work reliably again.

  2. Thanks for doing this video, I’m getting ready to do the exact thing on a STTNG. Great job and keep up the good work.

    -Dave

  3. Brilliant set of videos and EXACTLY what was needed to give me the confidence to repair my Theatre of Magic myself. One question though – how can you be sure that it is not either the DMD itself which has failed, or the power supply TO the DMD board? Many thanks for you efforts!
    David

  4. Are the videos not available? Theres blank spots where it looks like there used to be a video but can’t see anything.

    • Ooops.. looks like my older videos were referencing youtube in http and not https mode and now YouTube has disabled that. I believe I have fixed this and the videos should be back. Thanks for letting me know!

      • First if all, thank you so much for this. Creating such quality content is not easy and can be very time consuming. Appreciate it TONS! Going through the videos, I noticed part 2 seems to be marked “private” so not available to the public. Any chance we can get that changed? I’m getting ready to do this on my Getaway and don’t want to mess things up *gulp* 🤞

        Thanks Chris!

        Sincerely,

        Blake Anderson

Leave a Reply to admin Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.